Solution to the malfunction of air suspension springs
The use of Air springs in the automotive is becoming more and more common. So, when air suspension springs in failure, can you solve it? Today we're going to learn about the solution to the malfunction of air suspension springs.
For air suspension springs, the most common fault is the airbag airless and wrinkles. The causes of these two failures may be different, and the solution methods are not same. We need to carefully analyze the cause and use the correct method to deal with it.
Airbag airless
This problem is easy to check. We know that Air suspension Spring gas source is connected by the braking system, through the pressure protection valve, stored in a dedicated storage cylinder。 So this problem will cause by the following reason: the storage cylinder is airless or low pressure; Air pipes are blocked or bent; Connection rod of height valve falling off. Checking one by one will easy to find out the problem and solve it accordingly.
Airbag wrinkles
The problem occurs just because the airbag was pulled out too much and did not reset normal, resulting in Airbag wrinkles. The solution is to open connection between the axle and rubber connector on the rod under height valve and then upward lift the rod. When the airbag is full, put back the Rod. That way airbag can be returned to normal state.
Design of Air spring is not as simple as imagined, its function in the vehicle is also very important, so we should solve the problem timely in case it is malfunction so as to make sure the safety of the vehicle.